LEPRECHAUN 90 O.S.AWOODBURNING STOVESAFETY NOTICEPlease read this entire manual before you install and use your new room heater. Failure to follow in
has caught fire adjust the primary air settingsto suit the heat requirements.2. The logs will burn slowly towards the rear ofthe fire chamber and the
PRIMARY AIR SETTINGSMAXIMUM - Pull control lever (item 43) all the waytowards the front.LOW (MIN) - Push the control lever (item 43) all theway toward
WARNING: USE ONLY CERAMIC GLASS 5mmTHICK. ABUSE SUCH AS STRIKING, SLAMMINGAND USE OF SUBSTITUTE MAT E R I A L SSHOULD BE AVOIDED.FIRE SAFETYTo
LEPRECHAUN 90 O.S.A.WOODBURNING STOVEINSTALLATION & OPERATINGINSTRUCTIONSGENERALWhen installing, operating and maintaining yourLeprechaun 90 O.S.A
Rear Exit:Fit the heat shield as follows:Screw the four 4” 100mm x 1/4” 6mm tie bolts to theback panel (item 11). Fit the four 1” spacers (item31) ov
WARNINGDO NOT OBSTRUCT FREE AIR SUPPLY TO THEAIR INLET DUCT LOCATED AT THE BACK OFTHE STOVE.OUTSIDE AIR CONNECTIONThis stove may be connected direct t
7. The chimney system shall comply with the standard for Chimney’s Factory-Built Residential Type and Building Heating Appliances UL 103.8. Any openin
Chimney, installed in accordance with the manufac-turers instructions or a lined masonry chimneyacceptable to the authority having jurisdiction.
1. Leg2. Ashtray3. Base4. Base Heat Shield5. Combustion Chamber Base Plate6. Fire Door7. Side Panels8. Inside Fire Door9. Door Latch10. Top Side of To
THIMBLESThimbles for chimneys or vent connectors should beof fire clay (ASTM C 315, specifications for ClayFlue Linings), galvanised steel of minimum
between the outer wall of chimney section and shall be 12” (305mm). Chimney section concentric with and spaced 1” (25mm) away from connector by means
Comments to this Manuals